Page 1 of 2
WTB 7mmBR Brass
Posted: Mon Feb 01, 2016 10:43 am
by DW44VH
I recently purchased an XP-100 in 7mm BR and feel like I stole it, $400.00 Canadian, (sorry had to brag a little) I was wondering if anyone has any factory 7mm BR brass they would be interested in parting with.
Re: WTB 7mmBR Brass
Posted: Mon Feb 08, 2016 12:07 am
by Benjamn
I bought 6BR. Commercially available and can be had from lapua. Necked it up, easy peasy.
Re: WTB 7mmBR Brass
Posted: Mon Feb 08, 2016 5:15 am
by i26963
Re: WTB 7mmBR Brass
Posted: Mon Feb 08, 2016 12:07 pm
by DW44VH
10 minutes late to reply...story of my life LOL
Thanks Melvin
Re: WTB 7mmBR Brass
Posted: Mon Feb 08, 2016 1:14 pm
by i26963
DW44VH wrote:10 minutes late to reply...story of my life LOL
Thanks Melvin
Darn! Sorry you missed out. I will be on the lookout for some
Melvin
Re: WTB 7mmBR Brass
Posted: Mon Feb 08, 2016 7:20 pm
by 260 Striker
Midway USA shows 100 Lapua 6BR in stock for $93.99. Pricey but at least available. Brownells has same Lapua for $94.99. Best deal on Lapua is otmtactical.com in stock for $80.79 per 100. Midsouth Shooters has some Norma brass in stock for $88.70 so looks like you are going to pay $80 to $94 per 100 no matter whether Lapua or Norma.
Re: WTB 7mmBR Brass
Posted: Mon Feb 08, 2016 8:58 pm
by DW44VH
I use the Lapua 22-250 with good results. Probably a good way to go.
Re: WTB 7mmBR Brass
Posted: Mon Feb 08, 2016 9:45 pm
by dhagerty40x
nobody knows when remington will start making brass again. So using Lapua 6BR is about your only option right now.
Re: WTB 7mmBR Brass
Posted: Tue Feb 09, 2016 4:02 am
by Unsub
I necked out the 6 BR cases but found out the hard way that the flash hole is smaller in the 6BR and needs to be enlarged before necking.
Re: WTB 7mmBR Brass
Posted: Wed Feb 10, 2016 3:33 am
by Unsub
No small pin available and needed brass straight away. Shopping for this sort of stuff is not that easy down under.