Page 1 of 1

Little River Gun Club - Match Results - 28 Apr 18

Posted: Sun Apr 29, 2018 3:04 pm
by AtomicDogg
Results are now posted at: http://www.gaihmsa.org/Pages/LRGCMRBody.html

PDF version:
LRGC Match Results 28Apr2018.pdf
(47.95 KiB) Downloaded 236 times

Re: Little River Gun Club - Match Results - 28 Apr 18

Posted: Mon Apr 30, 2018 9:57 am
by 35isit
I see Melvin had a 108 Three Gun. Not bad for an old blind man who needs a walker :)) . Hope you guys turned in those C.B. scores. We really need to get that started again.

Re: Little River Gun Club - Match Results - 28 Apr 18

Posted: Mon Apr 30, 2018 11:07 pm
by jmoore
All that work they did was quite impressive! New benches, higher berms, repaired rails and critters, AND the new dedicated 1/2 scale line

Nice to be able to shoot 1/2 scale all day, especially now that the Rams are fairly resistant to .223 impacts. First go revealed that the 75 gr projectiles have to hit well above centerline in the rump to work. MixmasterOne is mechanically accurate enough to do that, but the operator has a hard time keeping the POA in the "correct" area on those big targets!

Re: Little River Gun Club - Match Results - 28 Apr 18

Posted: Tue May 01, 2018 12:30 pm
by 35isit
jmoore wrote:All that work they did was quite impressive! New benches, higher berms, repaired rails and critters, AND the new dedicated 1/2 scale line

Nice to be able to shoot 1/2 scale all day, especially now that the Rams are fairly resistant to .223 impacts. First go revealed that the 75 gr projectiles have to hit well above centerline in the rump to work. MixmasterOne is mechanically accurate enough to do that, but the operator has a hard time keeping the POA in the "correct" area on those big targets!
I assume that's on the bigbore targets.

Re: Little River Gun Club - Match Results - 28 Apr 18

Posted: Tue May 01, 2018 10:22 pm
by jmoore
35isit wrote:
jmoore wrote:All that work they did was quite impressive! New benches, higher berms, repaired rails and critters, AND the new dedicated 1/2 scale line

Nice to be able to shoot 1/2 scale all day, especially now that the Rams are fairly resistant to .223 impacts. First go revealed that the 75 gr projectiles have to hit well above centerline in the rump to work. MixmasterOne is mechanically accurate enough to do that, but the operator has a hard time keeping the POA in the "correct" area on those big targets!
I assume that's on the bigbore targets.
Not altogether clear was it? But, yes, BB. Half scale critters go down fine using the .223, assuming the bullet hits 'em.