WTB 7mm Int R dies

[dendvc]

Looking for a set of 7mm International Rim dies at a reasonable price.
I picked up a Wichita Single Shot in 7mm R Int. and the owner said he had the dies "someplace" and would look for them. well it's been a few weeks to no avail and I hate owning a gun I don't have any ammo for (just doesn't seem right).
Anybody got a set collecting dust?

Thanks,
Dennis
dendvc at yahoo dot com

[JACKIE40X40]

Hi,This is just a possible answer??? If all else fails and you can`t find the correct dies.. Did the Wichita come with brass? if you have the brass that has been fired in the gun,the 7x30 waters might work?
just too partial size the neck, and to seat the bullet?
How about it some of ya`ll rimmed 3030 case guys is this possible?..Its no fun having a new toy and can`t play with it!!!!

[260 Striker]

If you can find dies for the 7mm Bullberry they will work. 7mm Int-R just had a longer neck. Elgin designed the Int-R so a shooter could just size down 30-30 cases with no, or minimal trimming.

[IHMSA4895]

I have a Alum. Grip frame for the Wichita Int. Pistol (WIP) and a 7MM Int. neck die that my be possible to use it to neck size the 7 MM Int. R. 423-323-7880 THANKS

[Alvin]

You might try Dan at tripledeuce222@comcast.net
E-mail Address(es):
tripledeuce222@comcast.net

Back in December I bought a TC 7Int. Rimmed barrel from him. He also had dies and brass, but I already had those, so I was able to only purchase the barrel. Perhaps he still has the dies.

[dendvc]

Thanks guys for the Suggestions! I was out of town the last 2 weeks so I was unable to respond. I did send an email to Dan to see if he still has them so we will see. IHMSA 4895, I may contact you about the neck die once I can get some brass sized and fired. but do you have a picture of the alum grip frame because I am unfamiliar with it? you can text it to me @ 954 444 4876

Thanks again guys!!